Operations - Windsor Clipper CLP12 Operator Instructions Manual

SOLUTION
BRUSH
INT ON
CONT
STEP
STEP
STEP
STEP
VACUUM
ON
CLIPPER 86038240
Remove electrical cord and literature from
recovery tank. Fill solution tank (see filling
1
instructions page 3-5).
Plug cord into grounded outlet. Note: Be sure
dome is seated on recovery tank, and float
2
shut-off is installed correctly.
Adjust brush to proper setting. Note: For
good operation the brush must skim the
3
carpet. If circuit breaker trips raise brush to
prevent damage to motor or carpet.
Turn on brush and vacuum motor switches
("ON"="I"). Turn on solution switch for
4
continuous spray or set switch to intermittent
to allow use of trigger switches.

OPERATIONS

3-6