Maintenance; Machine Troubleshooting - Windsor LB2000I Operating Instructions Manual

MACHINE TROUBLESHOOTING

PROBLEM
Machine will not run
Electrical shock
Repeated circuit breaker tripping
Excessive vibration
CAUSE
Tripped circuit breaker
Circuit breaker tripped in
building.
Fuse in motor is blown
Power switch failure
Faulty power cord
Equipment not grounded
Receptacle not grounded
Internal wiring problem
Mechanical problem
Faulty circuit breaker
Pad not centered
Damaged or unevenly
worn pad.
Damaged pad driver.
86309600 (2000) BURNISHER 10/08/08

MAINTENANCE

SOLUTION
Reset
Check and reset
Replace
CAUTION: To reduce the risk of
electrical shock, unplug the
machine before opening fuse
holder.
Fuse will only open under extreme
conditions.
Investigate cause before replacing.
Test switch for continuity and
replace if necessary.
Replace
Follow grounding instructions
exactly.
Have an electrician inspect
building's wiring.
Ensure that the machine wiring
matches the appropriate wiring
diagram. Replace any wires or
components, which are short-
circuiting.
Higher amp draws indicate a
mechanical problem; find the
problem before using the machine.
Test circuit for continuity. Replace
circuit breaker if necessary.
Re-center pad.
Replace pad. Do not rest machine
on pad when not in use.
Replace.
4-1