Displaying A Picture On Your Hdtv Screen; Using The Front-Panel Buttons - Pace TDC777D Operator's Manual

OPERATING YOUR SET-TOP (cont.)

Displaying a picture on your HDTV screen

If your set-top is connected to your HDTV's component video or HDMI input and is turned on (the POWER
light is green), but your HDTV does not initially display a picture from your set-top, your HDTV may not
support your set-top's current output resolution (for further details on resolutions, see page 17). You therefore
need to change your set-top's output resolution as follows:
1. First press the POWER button on your remote control (POWER light goes red), then press the MENU
button.
2. Next, press the ZOOM button on your remote control (the button could be labeled ASPECT) until a
picture appears.
Each button-press changes your set-top's output resolution, which also appears on the TV screen.
After a few seconds, you should see the PACE USER SETTINGS menu.
3. Press the POWER button to remove this menu and return to normal viewing.

Using the front-panel buttons

L, R, U, and D
To move left/right/
up/down in an on-
screen menu/guide
SELECT button
To select items in
menus/guides
GUIDE
To display an on-screen guide
INFO
To display on-screen information
MENU
To display on-screen menus
POWER button
To turn your set-top on/off
POWER light (around button)
Lights green when your set-top is on; red
when your set-top is off; not lighted when
your set-top is disconnected from the
power supply
resolution lights
Relevant one lights up to
show the resolution of
the picture
(for live program or play-
back program)
TDC777D OPERATOR'S MANUAL (501-3432100)
front-panel display
Appears when your set-top is turned on
Shows the program channel number or the time
Also displays HDTV settings (see page 17)
BYPASS light
Lights when RF Bypass is on
MESSAGE light
Lights when there is an unread message
and when you make User Settings
Current output resolution from
your set-top
Video Format : 1080i
PACE USER SETTINGS
TV Aspect Ratio
TV Display Capability
Auto Pillarbox
Closed Captions
Front Panel Settings
Hard Disk Sleep Mode
HDMI Settings
Restore Defaults
Select[OK] Exit[POWER]
RECORD lights
Lights red to show whether one or two
programs are being recorded
IR RECEIVE light
Lights when your set-top
is receiving a signal from
your remote control
12