Operating Your Set-Top; Displaying A Picture On Your Hdtv Screen; The Front-Panel Lights - Pace RNG150N User Manual

OPERATING YOUR SET-TOP

Displaying a picture on your HDTV screen

If your set-top is connected to your HDTV's component video or HDMI input and is turned on (the
light is green), but your HDTV does not initially display a picture from your set-top, your HDTV may not
support your set-top's current output resolution (for further details on resolutions, see page 16). You therefore
need to change your set-top's output resolution as follows:
1. First press the POWER button on your remote control (
button.
2. Next, press the ZOOM button on your remote control (the button could be labeled ASPECT) until a
picture appears.
Each button-press changes your set-top's output resolution, which also appears on your TV screen.
After a few seconds, you should see the PACE USER SETTINGS menu.
3. Press the POWER button to remove this menu and return to regular viewing.

The front-panel lights

(power) light
Lights green when your set-top is on; not lighted when your
set-top is in standby or is disconnected from the power supply
(message) light
Lights yellow when there is an unread message and
when you make user settings (to show current setting)
(power) light goes off), then press the Menu
Display
Shows the time or the current channel number,
and the setting when you make user settings
(record) light
Lights red while a program is being
recorded
RNG150N / RNG200N USER GUIDE (501-3339201) B949/B950
Current output resolution from
your set-top
(power)
Video Format : 1080i
PACE USER SETTINGS
TV Aspect Ratio
TV Display Capability
Auto Pillarbox
Closed Captions
Front Panel Settings
HDMI Settings
Language Settings
Restore Defaults
Select[OK] Exit[POWER]
(remote) light
Flashes green when your set-top receives
a signal from your remote control
Resolution lights
Light up blue when your set-top has an input
signal at the resolution indicated
11