Siemens OpenScape Voice OpenStage 20 E SIP User Manual page 60

Enhanced phone functions
Step by step
Retrieve held call ?
Disconnect ?
User
Configuration
Connected calls?
Allow hold rem. No
=
Yes
Option = Save & Exit
60
Held call wait status
After placing a call on hold, you can replace the handset
and then decide whether to retrieve the call or discon-
nect.
Prerequisite: You placed a call on hold and replaced the
handset or (only OpenStage 20/20 G) pressed the
loudspeaker key in speakerphone mode.
A recall follows immediately and a pop-up menu ap-
pears on the display:
l
Select and confirm the option shown to resume the call
in speakerphone mode.
or
f
Select and confirm the option shown to disconnect the
call.
If you enabled "Hold and hang-up" (
the call is placed on hold for a defined time inter-
val (
with a recall to retrieve the call or disconnect.
Activating/deactivating the hold reminder tone
z You can also configure this setting via the WEB inter-
face
N
Press the key shown.
Select and confirm the option shown.
j
if nec.
Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
f
Select and confirm the option shown.
l
Select and confirm the option shown.
l
Select the option shown and confirm twice.
page 61) before the prompt is displayed
page 145.
page 62),