To Make An External Call - NEC ITL-8LD-1 - DT730 - 8 Button DESI Less Display IP Phone User Manual

TO MAKE AN EXTERNAL CALL

DT730/710 DT330/310
When dialed telephone number is registered in Per-
sonal Directory, the corresponding name information
will be displayed on LCD of DT730 Series while you
are hearing a ringback tone or are engaged in a con-
versation. According to the initial settings, the display
may differ from the following examples. For more infor-
mation, contact the system administrator.
Note:
Personal Directory Name Display function is
available only for DT730 Series.
Note:
This section describes the Normal Dial Mode.
Regarding the other mode, see
CALL USING SELECTIVE DIALING (DYNAMIC
DIAL PAD, PRESET DIAL)
STEP 1: Lift handset or press
tone.
1:25 PM
MIC DND
STEP 2: Dial the Central Office access code, e.g. 9.
1:25 PM
MIC DND
TO ORIGINATE A
in Chapter 5.
Speaker
key, receive dial
Station Number
of My Line
31313
MON 12 JUL 2010
>>>
Dialed Code
9
MON 12 JUL 2010
>>>
STEP 3: Dial desired telephone number.
(while hearing a ringback tone)
1:25 PM
MIC
STEP 4: Use handset or MIC to start a conversation.
Display indicates:
(while in a conversation)
• When dialed number is registered in Personal Directory
Name Information
registered in
Personal Directory
TOM JONES
MIC
Note: In the above case, a maximum of eight digits of
the number (including "*") can be displayed. If the
dialed number exceeds eight digits, "the first
seven digits of the number + *" or "the last seven
digits of the number + *" are displayed. For more
information, please contact the system adminis-
trator.
101
Dialed Code + Number
9XXXXXXXXX
MON 12 JUL 2010
>>>
Dialed Code
Elapsed Time
+ Number
00:05 9XXXXXX*
DND >>>