Table of Contents
Advertisement
User Programmable Features
Feature #1 - SecureCode
DEFAULT - 1 Press
SecureCode is a unique patented feature which allows you to custom select the num-
ber of Valet Switch presses in two stages, instead of a single "1 press", which would
be required in order to perform an Emergency Override� If any of the three anti-car-
jacking features are utilized, a customized SecureCode would also be required to turn
it off once it is fully activated� The SecureCode operation is described on page 12�
To custom program a new SecureCode:
Step 1 Follow Steps 1 to 4 in the previous "Programming Features" section to access
"feature #1"�
Step 2 Within 10 seconds slowly press and release the controller or transmitter's
"arm/lock" button the number of times equal to the desired SecureCode for stage 1,
allow the system to respond to each controller/transmitter button press with a siren
chirp before pressing the button again. A few seconds after the final button press, the
system will chirp the horn/siren confirming the total number for stage 1.
Step 3 Configure stage 2 of the SecureCode by pressing and releasing the "disarm/
unlock" button the number of times desired for the stage 2. The system will confirm
as it did for stage 1�
Feature #2 - Last Door Arming
Off
On w/o doors locking
On w/ doors locking
"Last Door Arming" has the system automatically arm itself every time you exit the
vehicle (the complete operation is described on pages 8 & 9)� This feature turns
that operation on or off, and with options of having Last Door Arming operate with or
without also locking the doors when the system does arm�
Feature #3 - Automatic Rearming
Off
On w/o doors locking
On w/ doors locking
"Automatic Rearming", described on page 11, prevents the system from becoming
accidentally disarmed by having it arm itself after being disarmed, if a door is not then
opened or the ignition turned on� Options are to have Automatic Rearming operate
with or without also locking the doors when the system does rearm�
Feature #4 - Starter Interrupt Functions
Alarm Only
Off
Automatic
Alarm & Anti-Grind
Alarm Only - The Starter Interrupt is operable whenever the alarm is armed�
Automatic - This will cause the Starter Interrupt output to automatically engage 90
seconds after the ignition switch is turned "off", and after disarming the system�
Off - Completely eliminates the Starter Interrupt output,
Alarm & Anti-Grind - This setting engages starter interrupt when the alarm is armed
AND when the system is in remote start mode� This prevents the starter from grinding
if the user accidentally turns the key to "START" during remote start�
20
(press "arm/lock" button to program) - DEFAULT
(press "disarm/unlock" button to program)
(press "trunk" button to program)
(press "arm/lock" button to program) - DEFAULT
(press "disarm/unlock" button to program)
(press "trunk" button to program)
(press "arm/lock" button to program) - DEFAULT
(press "disarm/unlock" button to program)
(press "trunk" button to program)
(press "start" button to program)
Advertisement
Table of Contents
