Table of Contents
Advertisement
Feature #11 Alarm Duration
Factory Default Setting
30 Seconds
press "arm/lock" button to program
(
Options:
press "disarm/unlock" button to program
60 Seconds
(
press "II" button to program
90 Seconds
(
press "III" button to program
120 Seconds
(
This feature allows four choices of the Alarm Duration, which is the period of time
for which the system sounding the siren (and/or horn, optionally) and flashes the
parking lights when it is triggered. Caution: Before lengthening the Alarm
Duration you should always check and determine if there are any local anti-
noise or nuisance ordinances in your area, to avoid the possibility of receiving
a violation citation.
Feature #12 Parking Light Illumination Upon Disarm
Factory Default Setting
On
Option:
Off
This feature affects the parking light operation when the system is disarmed. When
this feature is turned on, the parking lights flash once, and then turn back on for
external illumination for 30 seconds unless the ignition key is turned on during that
time. If this feature is turned off, the parking lights flash once only, and do not
illuminate. This feature only affects the Excalibur's parking light operation, and not
the interior light operation.
Feature #13 2nd Channel Also Disarms System
Factory Default Setting
On
Option:
Off
"2nd channel" is most commonly used to remotely open the vehicle's trunk, in
which case the alarm should also disarm. This feature, turned on, configures the
system to disarm when the 2nd channel is used. If turned off, the 2nd channel output
will still occur, with 2 chirps, but without the parking light flashes; and if armed, the
system will not disarm.
Feature #14 3 or 45 Second Arming Delay
Factory Default Setting
3 Seconds
(
press "arm/lock" button to program
Options:
press "disarm/unlock" button to program
15 Seconds
(
30 Seconds
(
press "II" button to program
press "III" button to program
45 Seconds
(
When the system is armed, whether by the controller, transmitter or by an automatic
)
)
)
press "arm/lock" button to program
(
press "disarm/unlock" button to program
(
press "arm/lock" button to program
(
(
press "disarm/unlock" button to program
)
)
)
Page - 30
Using the Excalibur System
Your Excalibur system is designed to deter theft of both your vehicle and its
contents. "Arming" your system turns on the protection, disabling the vehicle's
starter and locking the doors. Once the system is Armed, any intrusion attempt will
)
Activate it, sounding the electronic "Psyren" psycho siren and flashing the parking
and interior lights to attract attention. The unique and patented "2-in-1" Psyren
psycho siren actually produces the sounds of two different sirens at once, ensuring
that it won't be ignored like all of the other "common" car alarms. Disarming the
system turns off the protection, unlocking the doors and turning on the parking and
interior lights, allowing lighted access to, and normal use of, the vehicle.
There are two methods of arming the Excalibur:
1- The first method is to use the controller* or transmitter, by pressing and
releasing the "arm/lock" button. The system must not already be armed or be
in Valet Mode, and the vehicle's ignition key must be off.
2- The second method is Last Door Arming, which configures the system to
)
automatically arm itself every time you exit the vehicle. This method of arming
)
is programmable, and may be used or not used as desired.
Regardless of how it became armed, if the system is armed the window unit's Status
Light flashes in the red color.
*If the 2-way controller is used to operate the system, it will receive a signal
back and confirm that the arming operation was performed.
Arming Using the Controller or Transmitter
The system can always be armed from the controller or transmitter, if the ignition
)
key is "off" and the system is not in the Valet Mode. To arm the system, exit the
)
vehicle, close all of the doors, and simply press and release the "arm/lock" button
once.
The system's reaction: The parking lights will flash once, the siren will chirp
once and the Status Light will begin to flash red, confirming that the system is
armed.* In addition, the doors will lock and the starter interrupt will engage to
prevent any attempt to start the vehicle. Your security system is now fully armed,
and is ready to respond if an intrusion attempt is detected.
If the controller was used: Immediately after the system responds the control-
ler will chirp twice (or four times if a zone is bypassed), the "ARM" icon will
appear, the "locked lock" icon appears, confirming that doors have locked, and the
number of operating transmitters or controllers is briefly displayed.
)
*The system is described in its most common and basic configuration, with
doorlocks connected, and the interior lights connected. Also, the vehicle horn
may used in place of, or in addition to, the system's electronic siren.
Page - 7
Hide quick links:
Advertisement
Table of Contents
