Installing & Programming The Echo System - Omega ECHO TOUCH Operation And Installation Manual

The ECHO-TOUCH communicates with a window-mounted base unit which
is plugged directly into the host security system module. The window-mount
antenna should be mounted directly to the interior glass by utilizing the attached
adhesive pad (clean the glass before adhering) for the best performance. The
receiver/transmitter also contains alternative Status Lights and a Valet Switch.
these may be used, or the original items may be retained.
NOTE: It is recommended to fully charge the controller before use.
Host Omega Security
System Control
Module
--~
Step 2 Plug in and route the Echo
transmitter/receiver unit wiring harness.
Using the adhesive tape, mount the Echo
transmitter/receiver onto an interior glass
(carefully clean the surface).
-
(configurations vary)
Step 1 \ Echo Base
Locate & Transmitter/
Remove the \ Receiver Unit
security system's \
Echo port jumper \
connector (it has a \
Red wire loop). \
\
\
\
\
{!JJ\
~
Step 3 Program the Echo controller and the
\ \ original 1-way transmitters into the security system
(see the system's guide for instructions).