Choosing A Location For Your Printer; Locating The Printer & Optional Second Paper Tray - Oki OKIPAGE 8c Setup Manual

Choosing a Location for Your Printer

Your printer weighs approximately 52kg. It must be located
safely on a stable, flat, level surface, capable of supporting at
least this weight for an extended period.
If the optional second paper tray is installed, this weighs an
additional 20.5kg.
Do not attempt to lift the printer by yourself, ask
someone to help you.
Choose a location where the cables for power and computer
data can be installed safely without creating a trip hazard.
Ensure that there is adequate clearance on the left side (viewed
from the front), front, rear and above the printer to allow opening
of covers and rear exit, and for removal of paper trays.
For your safety, the AC power socket used to supply power to
your printer should ideally be switched, must be of the 3-pin
earthed type, and should remain easily accessible at all times.
The data cable used to connect your printer to the host computer
should be IEEE1284 bi-directional Centronics type printer
cable, no longer than about 1.8m.
Setup Guide
Locating the Printer & Optional Second Paper
Tray
1. Lay the 2nd paper tray face up in the position where the
printer is to reside.
1
The two locating pins (1) should be towards the front as
illustrated.
2. Lift the printer, position it over the 2nd tray with the front
at the same end as the two locating pins on the tray.
3. Gently lower the printer onto the tray, so that the two pins
locate into two corresponding holes on the underside of
the printer.
4. Remove the strips of adhesive tape sealing the top and
front covers.
7