Connecting Power To The Printer - Oki OKIPAGE 8c Setup Manual

2. Adjust the rear paper guide (1) if necessary for the correct
paper length. Do this by squeezing the top of the guide
and sliding it gently in the required direction.
1
3. If necessary, slide the two side paper guides (2) out far
enough to accomodate the width of the paper stock.
4. Place the stack of paper gently into the tray, then adjust
the side and rear guides to obtain a snug fit.
5. Reinsert the tray back into the printer and push it gently
all the way in.
Do not slam the tray in too hard. A full paper tray is heavy
and may cause internal damage.
Setup Guide

Connecting Power to the Printer

A suitable AC power cable was supplied with your printer,
terminated with the appropriate plug for connection to a
2
standard AC wall outlet.
1.
2.
For your safety the AC power must come from a suitably
rated 3-pin socket. This should ideally be switched and
must remain easily accessible at all times.
Ensure the printer on/off switch (1) is off.
2
Connect the cable to the 3-pin power socket (2) on the rear
of the printer.
1
13