Cisco CallManager Release 3.0(10 Specification page 37

Table 3 Cisco CallManager Release 3.0(9) Resolved Caveats (continued)
DDTS Number Summary
CSCdt44128 6608 sends disconnect when it does not
receive an alerting fast enough.
CSCdt48748 When Windows 2000 Administrator
account name is changed, i.e., to
"callmngradmin," the installation
reports an error changing the admin
password.
CSCdt49457 STI backup may fail with large
database.
CSCdt51159 Resetting h.225 device by any means
causes AnonymousDevice failure.
CSCdt51281 ISDN layer3 stack on PRI-EURO
response to INFOR in state U4
CSCdt52273 MeetMe conference button does not
reset T302 timer.
CSCdt52506 CDR database will not be restored.
CSCdt53123 Cisco CallManager does not register
with gatekeeper until the
Cisco CallManager is stopped and
started.
CSCdt53834 Cisco Catalyst 6000 8 Port Voice E1/T1
and Services Module does not support
G711Alaw.
CSCdt54279 Change of zone name in Gatekeeper
device requires the administrator to stop
and start the Cisco CallManager.
78-13493-02
Explanation
A Cisco CallManager service parameter
was extended to correct this behavior.
After upgrading to Cisco CallManager
3.0(9), the customer no longer experienced
this problem.
A newly created backup prevents this
behavior.
A Cisco CallManager code change corrects
this behavior.
A Cisco CallManager code change corrects
this behavior.
A new timer corrects this problem.
When backing up Cisco CallManager
databases larger than 2 GB to a local or
network drive, the file is clipped while
being added to the TAR file.
The backup software was fixed to get rid of
a 2 GB limitation.
A button now exists to reset the gateway.
The code that caused this caveat only
checked for G711 muLaw. The code now
checks for G711ALaw.
The code now changes the gatekeeper zone,
and the administrator uses the Reset
Gatekeeper button to reset gatekeeper.
Release Notes for Cisco CallManager Release 3.0(10)
Resolved Caveats
37