Cisco CallManager Release 3.0(10 Specification page 29

Table 2 Cisco CallManager Release 3.0(10) Resolved Caveats (continued)
DDTS Number Summary
CSCdu10146 Locations bandwidth calculation is
wrong with software conference and
codec change.
CSCdu12450 AnonymousDevice does not work until
Cisco CallManager stops/starts.
CSCdu13710 Dual-tone multifrequency (DTMF)
intermittenly fails.
CSCdu19849 Cisco CallManager may crash when a
user performs a directory look up to a
partially initialized directory.
CSCdu20435 lineSetupTransfer sometimes returns
call in ONHOLD not OHPT state.
CSCdu20892 Pilot point stops working due to
CtiDeviceOpenReq failure.
CSCdu43517 Cisco IP Phone 7940/7960 headset
transmit level is too low versus the
handset level.
78-13493-02
Explanation
A caller initiates a call to a low bandwidth
(30 KB) location with codec G.729. The
caller initiates a conference using a
software conference bridge, and the codec
changes to G.711. The called party in the
low bandwidth location changes to G.711
and joins the conference even though not
enough bandwidth exists.
A code change corrects this behavior.
A Cisco CallManager code change corrects
this behavior.
A Cisco CallManager code change corrects
this behavior.
This problem occurred because the
directory was not properly configured.
The TSP was not setting the TAPI call state
appropriately.
The customer's pilot point was not
registering with digit analysis.
Three decibals were added to the headset
microphone.
Release Notes for Cisco CallManager Release 3.0(10)
Resolved Caveats
29