1.9.2 Manual speed input
1. Press [RADAR MENU], [0] to show the FUNCTIONS 2 menu.
2. Press the [6] key to select menu 6 SHIP SPEED.
3. Press the [6] key to select (or highlight) MAN.
4. Press the [ENTER] key to confirm selection. At this point, "MAN = 00.0KT" appears on
the FUNCTIONS 2 menu.
5. Enter the ship speed by hitting corresponding numeric keys followed by the [ENTER]
key without omitting leading zeros, if any. For example, if the ship speed is 8 knots,
press [0], [8], [ENTER].
6. Press the [RADAR MENU] key to close the FUNCTIONS 2 menu. The ship speed
readout at the top right-hand corner shows own ship speed entered followed by the
label "MAN."
1.10 Presentation Modes
This radar has the following presentation modes:
Relative Motion (RM)
Head-up:
Unstabilised
Head-up TB: Head-up with gyrocompass-stabilized bearing scale (True Bearing) where
the bearing scale rotates with the gyrocompass reading.
Course-up:
Gyrocompass-stabilized relative to ship's intended course
North-up:
Gyrocompass-stabilized with reference to north
True Motion (TM)
North-up:
Ground or sea stabilized with gyrocompass and speed inputs
1.10.1 Selecting presentation mode
Press the [MODE] key on the control head. Each time the [MODE] key is pressed, the
presentation mode and mode indication at the upper left-hand corner of the screen change
cyclically.
[MODE] key
HL
PANEL
MODE
AUDIO
OFF
BRILL
OFF
1
2
3
OFF
LOST
VECTOR
CENTER
TARGET
4
5
6
ACQ
CHART
EBL
MARK
ALIGN
TARGET
7
8
9
DATA
TARGET
CU, TM
A/C
TRAILS
RESET
AUTO
TARGET
CANCEL
CANCEL
0
ENTER
1-10
RADAR
PLOT
NAV
MENU
MENU
MENU
Figure 1-11 Control head, key panel
Loss of Gyrocompass Signal
Loss of Gyrocompass Signal
When the gyro compass signal is lost, the
presentation mode automatically becomes
head-up and the HDG (heading) readout at
the top right-hand corner shows ***.*.
When the gyrocompass signal is restored,
the indication SET HDG appears at the
upper-right corner£ o n the screen. Press the
[MODE] key, and the asterisks go off. Align
the HDG readout with the gyrocompass
reading, referring to the paragraph 1.8.
Finally, press the CANCEL key to erase the
message SET HDG.