Initializing The Gyro Readout - Furuno FR-2125V Operator's Manual

1.8

Initializing the Gyro Readout

When a gyrocompass is interfaced with the radar, ship's heading is displayed at the top
right-hand corner of the screen. Upon turning on the radar, align the on-screen HDG read-
out with the gyrocompass reading by the procedure shown below. Once you have set the
initial heading correctly, resetting is not usually required. However, if the HDG readout
goes wrong for some reason, repeat the procedure to correct it.
1. Press the [RADAR MENU] key to display the FUNCTIONS 1 menu.
2. Press the [0] key twice to display the FUNCTIONS 3 menu.
3. Press the [9] key to select the option GYRO SETTING.
4. Rotate the EBL control to adjust the gyrocompass (heading) reading.
5. Press the [ENTER] key to confirm the setting.
1-8
[FUNCTIONS (1)]
1 TARGET TRAILS
2 TARGET ALARM
3 ORIGIN MARK
4 INDEX LINES
5 ZOOM
6 PULSE WIDTH
7 INT REJECT
8 ARPA
9 VIDEO PLOT
0 [FUNCTIONS (2)]
Figure 1-8 FUNCTIONS 1 menu
[FUNCTIONS (3)]
1 [FUNCTIONS (2)]
2 [RADAR (1)]
3 [FUNCTION KEY 1]
4 [FUNCTION KEY 2]
5 [FUNCTION KEY 3]
6 [FUNCTION KEY 4]
7 RADAR 1/2
8 INTER SWITCH
9 GYRO SETTING
0 [FUNCTIONS (4)]
Figure 1-9 FUNCTIONS 3 menu
(1 or 2)
(1 to 10)