Set-Up Of Video Plotter Display - Furuno FR-2125V Operator's Manual

6.4

Set-up of Video Plotter Display

6.4.1 Hiding/Showing graphics
1. Press [NAV MENU], [8] to display the PLOT DISP SELECT menu. Current selections
appear in reverse video. Blank items have been turned off on the VIDEO PLOTTER
INITIAL SETTING menu. For further details see paragraph 6.10 Initial Settings.
2. Press appropriate numeral key twice to hide or show graphic.
3. Press the [ENTER] key.
4. Repeat steps 2 and 3 to hide or show other graphics.
5. Press the [NAV MENU] key to close the menu.
Note: LAND DENSITY fills (ON) or hollows (OFF) land on an electronic chart. Land will be
hollow when wrong card or wrong scale is used regardless of LAND DENSITY setting.
6.4.2 Hiding/Showing nav data
You may select what navigation data to display on the video plotter display as follows:
1. Press the [NAV MENU] key to display the NAV INFORMATION 1 menu.
2. Press appropriate numeral key to select both item and option. Press the [ENTER] key
to register selection.
6-4
[PLOT DISP SELECT]
1 [VIDEO PLOTTER 1]
2 DANGER HIGHLIGHT
3 COAST LINE
4 LAND DENSITY
5 PLACE NAME
6 MARK
7 OWN SHIP PLOT
8 TARGET PLOT
9 CONTOUR LINE
0 GRID
Figure 6-3 PLOT DISP SELECT menu
[NAV INFORMATION 1]
1 [VIDEO PLOTTER 1]
2 SELECT NAVAID
3 OWN SHIP POSN
4 POSN
5 +CURSOR DATA
6 WPT DATA
7 [NAV LINE]
8 [WAYPOINT]
9 WIND DATA
0 [NAV INFORMATION 2]
Figure 6-4 NAV INFORMATION 1 menu
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/SEPARATE/CONTINUE
OFF/ON
OFF/ON
OFF/ON
GPS+LC/DEAD RECKONING
OFF/ L/L
xx xx.xxx N/S
xx xx.xxx E/S
OFF/ L/L
OFF/REL/TRUE
OFF/ON