Outputting Data Through The Network - Furuno 1823C Operator's Manual

6. DATA TRANSFER
10. Press the RCV soft key followed by the [ENTER] knob.
The message "START RECEIVING DATA VIA NETWORK." is displayed. If
no data could be found, the message "(HOST NAME)' IS NOT FOUND."
appears.
11. When the transfer is completed, the message "DATA TRANSFER
COMPLETED. PUSH ENTER KNOB TO CONTINUE." appears. Push the
[ENTER] knob to finish.
12. Press the [MENU] key to close the menu.
6.5

Outputting Data Through the Network

Follow the procedure below to output data through the network.
1. Press the [MENU] key to open the menu.
2. Press the SYSTEM CONFIGURATION, SYSTEM SETUP, PORT SETUP
and OUTPUT THROUGH NETWORK soft keys.
3. Select sentence with the trackball.
4. Press the ON/OFF soft key to turn sentence on or off.
5. Press the RETURN soft key.
6. Press the [MENU] key to close the menu.
AAM: Waypoint arrival alarm, APB: Autopilot sentence B, BOD: Bearing origin to
destination, BWR: Bearing and distance to waypoint - rhumb line, DPT: Depth,
GGA: Global positioning system(GPS) fix data, GLL: Geographic position -
latutude/longitude, GTD: Own ship information-TD, MTW: Water temperature,
RMA: Recommended minimum specific LORAN-C data, RMB: Recommended
minimum navigation information, RMC: Recommended minimum specific
GPS/TRANSIT data, VHW: Water speed and heading, VTG: Course over ground
and ground speed, WPL: Waypoint location, XTE: Cross-track error, measured,
ZDA: Time and date, HDT: Heading true, HDG: Heading, deviation and variation,
MWV: Wind speed and angle
6-10
AAM --
APB --
BOD --
BWR --
DPT --
GGA --
GLL --
GTD --
MTW --
RMA --
RMB --
RMC --
VHW --
VTG --
WPL --
XTE --
ZDA --
HDT --
HDG --
MWV --
Select sentence menu
SELECT
SNTNC
ON/OFF
RETURN