Genlock Adjustment; When Performing The Operations - Panasonic AW-HE120KE Operating Instructions Manual

Genlock adjustment

 Genlock adjustment 
The genlock adjustment is performed to achieve phase
alignment by applying external synchronization (genlock)
when a multiple number of cameras will be used or when the
unit will be used in combination with other devices.
This unit supports BBS (Black Burst Sync) and tri-level sync
external synchronization signals.
Ask your dealer to perform this adjustment.
(Use a dual-trace oscilloscope for the adjustment.)
 Horizontal phase adjustment 
Observe the waveforms of the external sync signal input
( tri-level sync signal) and video signal output on the
dual-trace oscilloscope, and use the wireless remote control
or controller to bring the horizontal phase into alignment.
Bring the horizontal phase into alignment.
Example: When the tri-level sync phase is adjusted

When performing the operations

using the wireless remote control
1
Follow the operation steps in "Basic
operations" (page 31) to display the Top Menu.
2
Press the [] or [] button to bring the cursor
to "System".
Top Men u
Camera
System
Mainte nan c e
28
External sync signal
input (tri-level sync
signal)
Video signal output
Sc e ne : Sc en e1
3
Press the [] button.
The "System" sub-menu is displayed.
S y s t e m
G e n l o c k
O u t p u t
O t h e r
R e t u r n
4
Press the [] or [] button to bring the cursor
to "Genlock", and press the [] button.
The "Genlock" sub-menu is displayed.
G e n l o c k
H o r i z o n t a l P h a s e
H o r i z o n t a l P h a s e S t e p
R e t u r n
5
Press the [] or [] button to bring the cursor
to "Horizontal Phase", and press the [] button.
The "Horizontal Phase" value starts blinking.
6
Press the [] or [] button to change the
"Horizontal Phase" value, adjust the value
so that the horizontal phase is brought into
alignment, and press the [] button.
The extent of the phase adjustment can be selected
using "Horizontal Phase Step".
7
Press the [MENU] button for 2 seconds.
The camera menu display is exited.
When performing the operations using the controller
These operations can be performed using the camera
menus by following the operation steps in "Basic operations"
(pages 29 to 36).
0
1