Genlock Adjustment (Aw-He50S Only); Genlock Adjustment - Panasonic AW‑HE50HE Operating Instructions Manual

Genlock adjustment (AW‑HE50S only)
w Genlock adjustment
w
The genlock adjustment is performed to achieve phase
alignment by applying external synchronization (genlock)
when a multiple number of cameras will be used or when
the unit will be used in combination with other devices.
This unit supports the BBS signal as the genlock signal.
Ask your dealer to perform this adjustment.
(Use a dual‑trace oscilloscope for the adjustment.)
(The genlock function is not available with the AW‑HE50H.)
q Horizontal phase adjustment
w
Observe the waveforms of the external sync signal input
(black burst signal) and video signal output on the dual‑trace
oscilloscope, and use the wireless remote control or
controller to bring the horizontal phase into alignment.
Bring the horizontal phase into alignment.
When performing the operations
using the wireless remote control
1
Follow the operation steps in "Basic
operations" (page 31) to display the "Top
Menu".
2
Press the [] or [] button to bring the cursor
to "System".
To p M e n u
Came ra S c e n e : F u l l A u t o
Syst em
Main te n a n c e
External sync signal
input (black burst signal)
Video signal output
26 (E)
3
Press the [] button.
The "System" sub‑menu is displayed.
Sy s t e m
G e n lo c k
O u t pu t
O t h er
R e t ur n
4
Press the [] or [] button to bring the cursor
to "Genlock", and press the [] button.
The "Genlock" sub‑menu is displayed.
G e n l o c k
H o r iz o n t a l P h a s e
S u b ca r r i e r P h a s e
C o ar s e
F i ne
H P ha s e . S C F i n e S t e p
R e t ur n
5
Press the [] or [] button to bring the cursor
to "Horizontal Phase", and press the []
button.
The "Horizontal Phase" value starts blinking.
6
Press the [] or [] button to change the
"Horizontal Phase" value, adjust the value
so that the horizontal phase is brought into
alignment, and press the [] button.
7
Press the [MENU] button for 2 seconds.
The menu display is exited.
When performing the operations using the controller
These operations can be performed using the camera
menus by following the operation steps in "Basic operations"
(pages 29 to 36).
0
9 0 °
0
1