Tools Required For Assembly - Agri-Fab 45-01754 Owner's Manual

AssEMBLY INsTRuCTIONs

TOOLs REquIRED FOR AssEMBLY

(1) Screwdriver
(1) Pliers
(2) 7/16" Wrenches
(2) 1/2" Wrench
(2) 9/16" Wrenches
1. Remove the hardware pack and all loose parts from
the carton. Be sure the carton is empty before
discarding.
2. Lay out and identify all the parts and hardware as
shown on pages 2 and 3.
3. Place the latch lock lever through the slot in the draw bar
tongue. Assemble the 5/16" x 3-3/4" hex bolt through
the tongue, lever and two 5/16" hex nuts (SEMS) (one
on each side of the lever). Assemble a 5/16" nylock
nut onto the end of the bolt and tighten so that the
bolt can still rotate freely. Tighten the two 5/16" nylock
nuts against the sides of the latch lock lever so that
the lever is centered in the slot. See figure 1.
5/16" HEX NUTS (SEMS)
DRAWBAR TONGUE
5/16" x 3-3/4"
HEX BOLT
FIGuRE 1
4. Hook the
latch lock lever. Use the spring puller tool to hook
the long end of the spring into the square hole in the
tongue. The spring puller tool can be stored when
finished. See figure 2.
FIGuRE 2
5. Assemble the end of the hitch bracket to the front of
the drawbar tongue using two 3/8" x 1-1/4" hex bolt
LATCH
and 3/8" nylock nut. Tighten. See figure 3.
LOCK
6. Assemble the hitch pin to the tongue and hitch bracket
LEVER
and secure it with the hair cotter pin. See figure 3.
5/16"
NYLOCK
NUT
FIGuRE 3
4
short end of the spring into the hole in the
SPRING PULLER TOOL
HITCH
BRACKET
HAIR
COTTER
PIN
LONG END
OF SPRING
LATCH LOCK
LEVER
HITCH PIN
3/8" x 1-1/4"
HEX BOLT
3/8" NYLOCK
NUT