Tools Required For Assembly - Agri-Fab 45-0270 Owner's Manual

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(
1) Screwdriver
(1) Pliers
(2) 7/16" Wrenches
(2) 1/2" Wrenches
(2) 9/16" Wrenches
(2) 3/4" Wrenches
RECOMMENDED ITEMS
(1) Grease Gun
(4) Small bricks or blocks of wood (2" x 4") for
chocking the wheels.
IMPORTANT:
Due to the weight of the cart, we
recommend that you have someone assist you in
lowering the cart onto its wheels after it has been
assembled.
1. Remove the hardware pack and all loose parts
from the carton.
before discarding.
2. Lay out all the parts and hardware as shown on
pages 2 and 3.
3. Position cart body halves upright on a smooth
level surface such as a garage floor or a paved
driveway. See figure 1.
4. Assemble halves together using four 1/4" x 1/2"
hex bolts and 1/4" (SEMS) hex nuts as shown in
figure 1. Do not tighten at this time.
1/4" x 1/2" HEX BOLT
FIGURE 1
Be sure the carton is empty
1/4" HEX NUT (SEMS)
DO NOT LEAVE THE CART UNATTENDED IN
UPRIGHT POSITION DURING ASSEMBLY. A
FALLING CART CAN CAUSE PERSONAL INJURY!
PAY CLOSE ATTENTION TO THE STABILITY OF
THE CART WHILE IT REMAINS IN AN UPRIGHT
POSITION. FOR BEST STABILITY, ASSEMBLE
ON A SMOOTH, LEVEL SURFACE.
5. Position the tailgate reinforcement bracket on out-
side of cart as shown in figure 2. Assemble to the
bottom of the cart body using four 5/16" x 3/4"
truss head bolts and 5/16" (SEMS) hex nuts. Do
not tighten. See figure 2.
6. Position the tailgate guides with the holes to the
rear as shown in figure 2. Assemble the guides to
the inside of the cart using four 1/4" x 1/2" hex
bolts and 1/4" (SEMS) hex nuts. Do not tighten.
7. Assemble two 1/4" x 1/2" hex bolts and 1/4" (SEMS)
hex nuts to the top rear corners of the cart. Do not
tighten. See figure 2.
8. Tighten the four truss head bolts assembled in step 5.
Tighten the four hex bolts assembled in step 6 and
the two hex bolts assembled in step 7.
Tighten the four hex bolts assembled in step 4,
keeping the bottom of the cart body halves even.
5/16" HEX
NUT (SEMS)
TAILGATE
REINFORCEMENT
BRACKET
FIGURE 2
4
CAUTION
1/4" HEX NUT (SEMS)
TAILGATE GUIDE
1/4" x 1/2"
HEX BOLT
5/16" x 3/4"
TRUSS HEAD BOLT
1/4" x 1/2"
HEX BOLT
1/4" HEX
NUT (SEMS)