Installing The Charcoal Filter - GE JVM1490 Installation Instructions Manual

Installation Instructions
MOUNT THE OVEN
(continued)
_ Insert 9 self-aligning screws
_l tt_
(V('-28 x. ¼ ) through outer
top cabinet holes. Turn two
fllll turns on each screw.
_ Tighten center
screw completely.
NOTE: Use self-aligning screw, Vt"-28 x 2%", on
IVM 1790 and self=aligning screws, Vt"-28 x. w ,
on .[VM 1490, SCA 1000, and SCA 1001.
[] Tighten the outer two screws to the top of the
o;en. (_hile tightenino screws, hold the o;en
in place against the wall and the top cabinet.)
_ Install grease filters. See the Owner's Manual
packed with the oxen.
INSTALLING THE
CHARCOAL FILTER
_ Remove 9 top of ove]i,just above the
_ screws o]_
g]'i]] e pam_el, usi m_ _, ,_ [ screwdriver. Rein ove
o]_e sc]'ew om_[he ]ef[ side.
_ ()pe]_ the door.
_ Remove the g]i]]e.
Side--_
Screw
J
J
•Screws
_ Insert the filter into the oven as shown,
maneuvering it behind the plastic grille until it fits
squarely into place. It will rest at an angle behind
the plastic grille on two side SUl)port tabs and in
fl'ont of the right rear tab. When proi)erly
installed, the wire mesh of the filter should be
visible fl'om the fl'ont.
_ Replace the grille and the 2 top screws.
[] Close the door and replace left side screw.
Insert mesh-side down
22