Mount The Oveu - GE JVM1490 Installation Instructions Manual

Installation Instructions
MOUNT THE OVEN
FOR EASIER INSTAI,I.A_TION AND PERSONAI.
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your (abinet is metal, use the nvlon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet fl'ont hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from over
tightening screws.
NOTE: When m()tmting
the oven, thread power
cord through hole in
bottom of top cabinet.
Kee I) it tight throughout
Steps 1-3. Do not pinch
cord or lilt oven by
pulling cord.
[] I,itt oven, tilt it
fin'ward, and hook
slots at back bottom
edge onto two lower
tabs of m()tmting plate.
_ Rotate
fi'ont (If oxen l1 I)
against (abinet bottom.
_Insert a sell=aligning screw through top center
cabinet hole. Tempora_ilv secm'e the oven by
turning the screw at least two full turns alter the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord tight.
Be careful not to pinch the cord, especially when
mounting flush to bottom of cabinet.
CabinetFront
CabinetBottomShelf
FillerBlock
T quivalent
to Depth
of Cabinet
Recess
Self-AligningScrew
OvenTop
_ Attach the oxen to the top cabinet.
_Insert 2 self-aligning screws
_I zt
(J/('-98 x. ¼ ) through outer
top cabinet holes. Turn two
till turns on each screw.
U
_ Tighten center
screw completely.
NOTE: Use self-ali.,*ning, screw, ¼"-28 x _2_ :' ", on
JVM 1790 and sell=aligning screws, ¼"-28 x 3 V(',
on .[VM 1490, SCA 1 f)00, and SCA 1f)f}1.
[] Tighten the outer two screws to the top of the
oxen. (X._bile tightenin(* screws, hold the oxen
in place against the wall and the top cabinet.)
_ Install grease filters. See the Owner's Manual
packed with the oxen.
18