Switch Ports - Avaya Cajun P550R Release Notes

Problem:
Workaround:
50-Series
Supervisor
Module

Switch Ports

Problem:
Workaround:
RIP
Problem:
Workaround:
610-0184-095
When the 80-series Supervisor module boots, the switch displays
the following error message in the CLI:
Undefined Error -- FILE:gqswport.cLINE:449 Value
0xfffffffc: Error changing the GQ 'port use
diffserv' flag
Ignore this message.
The following problem has no workaround:
The display on the P880 switch M5500R-SUPA supervisor
module may not initialize properly. However, if it becomes
the active supervisor module, the display becomes functional
and displays the proper information.
The following problem has no workaround:
While switch port parameters are reflected across all ports of
a Hunt group, spanning tree parameters are not. If you
change the spanning tree priority of the flood port of a Hunt
group, but that port does not come up first when bringing up
the Hunt group, the spanning tree priority for the group
reverts to the default.
If a switch port is moved from Bind to Receive to Static, all
previously bound VLANs are not removed.
* Note: This is NOT a problem with the Bind to All setting.
Remove VLANs manually from a port when changing a switch port
connection from Bind to Receive to Static.
Configuring a RIP V1/V2 interface sends V2 packets to a V1
interface.
If the corresponding interface is in RIP v1, configure your interface
to RIP v1.
June 14, 2001
27