Powering On/Off The Projector; Powering On The Projector - ViewSonic Pro10100 User Manual

Powering On/Off the Projector

Powering On the Projector

1. Securely connect the power cord and signal cable. Power on the switch 1 and
the Power LED flashes Blue.
2. Turn on the lamp by pressing the
projector or on the remote control 2. The Power LED will turn blue.
The startup screen will display in approximately 10 seconds. The first time you
use the projector, you will be asked to select the preferred language and power
saving mode.
3. Turn on and connect the source that you want to display on the screen
(computer, notebook, video player, etc). The projector will detect the source
automatically. If not, push the menu button and go to "OPTIONS".
Make sure that "Auto Source" has been set to "Off".
` If you connect multiple sources at the same time, press the direct source
buttons on the control panel or on the remote control to switch between
inputs.
1
Turn on the projector first and then select the signal sources.
" " button either on the control panel of the
Sync
Shift
19
2
Source
Power On
Pattern Standby
VGA Video HDMI
BNC S-Video DVI
Sync Blank Source
Vol +
Exit Mute
Vol -
LENS
Menu Memory
Focus Zoom Shift
Lamp PW RGB Gain Mode
1 2 3
PIP Geo Blend
4 5 6
Aspect
MyButton Keystone
7 8 9
RC ID Reset
0