Integra DTR-30.5 Instruction Manual page 25

Note
• You can cancel Audyssey MultEQ ® Room Correction and
Speaker Setup at any point in this procedure simply by
disconnecting the setup microphone.
• Do not connect or disconnect any speakers during
Audyssey MultEQ Room Correction and Speaker Setup.
• If the AV receiver is muted, it will be unmuted automatically
when Audyssey MultEQ Room Correction and Speaker
Setup starts.
• Changes to the room after Audyssey MultEQ Room
Correction and Speaker Setup requires you run
Audyssey MultEQ Room Correction and Speaker Setup
again, as room EQ characteristics may have changed.
Error Messages
While Audyssey MultEQ Room Correction and
Speaker Setup is in progress, one of the error
messages below may appear.
MultEQ: Auto Setup
Ambient noise is too high.
Retry
Cancel
Error message
The options are:
Retry:
Try again.
Cancel:
Cancel Audyssey MultEQ Room Correction and
Speaker Setup.
• Ambient noise is too high.
The background noise is too loud. Remove the
source of the noise and try again.
• Speaker Matching Error!
The number of speakers detected was different
from that of the first measurement. Check the
speaker connection.
• Writing Error!
This message appears if saving fails. Try saving
again. If this message appears after 2 or 3
attempts, contact the dealer from whom you
purchased this unit.
• Speaker Detect Error
This message appears if a speaker is not detected.
"No" means that no speaker was detected.
Tip
• See "Speaker Configuration" for appropriate settings
(➔ page 11).
En-25
The setup of the speaker can be done manually
(➔ page 54).
The setup of the volume level of each speaker also
can be done manually (➔ page 55).
Using a Powered Subwoofer
AUDYSSEY
If you're using a powered subwoofer and it outputs
very low-frequency sound at a low volume level, it
may not be detected by Audyssey MultEQ Room
Correction and Speaker Setup.
If the "Subwoofer" appears on the "Review Speaker
Configuration" screen as "No", increase the
subwoofer's volume to the half-way point, set it to its
highest crossover frequency, and then try running
Audyssey MultEQ Room Correction and Speaker
Setup again. Note that if the volume is set too high
and the sound distorts, detection issues may occur,
so use an appropriate volume level. If the subwoofer
has a low-pass filter switch, set it to Off or Direct.
Refer to your subwoofer's instruction manual for
details.
Turning On & Basic Operations