Initial Startup Parameters - Eaton Powerware 9170+ UPS 3–18 kVA User Manual

UPS STARTUP

Initial Startup Parameters

74
+
Eaton 9170 UPS (3–18 kVA) User's Guide
18. The UPS front panel display automatically turns on whenever input
power is present and at least one power module is installed. Set up
the initial operating parameters through the front panel display (see
"Initial Startup Parameters" on page 74).
NOTE The unit has no physical On/Off switch. Access the UPS On/Off function through the
front panel display.
NOTE If the UPS has been manually set to operate in Bypass or Battery mode, change the
System Control Mode Preference (menu 4 1) to Auto to return to normal Auto mode operation.
19. If applicable, test proper operation of optional external control
signals and computer communication before connecting the load.
(See "DB-9 Communication Port" on page 92 for details.)
20. If there are receptacles on the UPS rear panel, plug the equipment
to be protected into the UPS output receptacles.
NOTE DO NOT protect laser printers with the UPS because of the exceptionally high power
requirements of the heating elements.
21. Turn on the equipment that is connected to the UPS.
22. If there is an external bypass switch, turn it to UPS. Otherwise,
close the load distribution circuit breaker(s).
The first time the UPS is turned on, you must set or verify certain
operating parameters before placing the UPS into operation. To set
these initial configuration parameters:
1. Enter the correct user security password: 0377. Move left and right
by pressing the buttons below the <- and -> on the display. To
change the value of the selected digit, press the
When the password shows 0377, press the
ENTER PASSWORD
Password − 0000
<−
S 164201393 Rev E www.eaton.com/powerquality
button.
−> ESC
Y and B buttons.