Gas - GE Monogram ZEW145V Installation Manual

Installation
Component Cooktop _vstem
Connect
Gas
st< 6
Connect
Electrical
• Install the supplied pressure regulator in gas
supply line as close to the cooktop irflet as
possible. Allowances for ventilation ducting
may be required.
- The regu later should be installed with the
arrow pointing in the direction of gas flow.
• Install a manual gas shut-off valve where it
will be easily reached. Be sure the user knows
where and how to shut off the gas supply.
• Appropriate flare union adapters are
required at each end of a flexible connector.
• Turn on the gas and check for leaks. Use a
liquid leak detector at all connections in the
system. A pressure test fitting is located on
the pressure regulator.
NOTE:If local codes permit, use 5 foot AGA-
certified flexible metal gas supply line. 3/4"or 1/2"
I.D. to match gas supply line.
Do not use old, previously used flexible line.
Do
not use a flame to
check for leaks.
Connect electrical to downdraft vent
• Connect tim 3-pin plastic plug fi'om tim
blower/motor assembly to tim 3-pin plastic
socket on tim underside of tim vent controls.
• Fasten the wire box on tim conduit over tim
l)lug and onto tim bottom of tim control box
with screws provided.
The blower conduit is long enough to reach
the vent connection when installed in the
cabinet below. The conduit will also reach
some blower installations below the cabinet
floor.
• If the blower conduit is not long enough to
reach the vent connection, the leads can be
extended.
1-1/4"
Solid Piping
or Flexible
Connector
_ hut-Off
Valve
_ Pipe Stub
To
add conduit length:
• Install an appropriate junction box neat" the
blower.
• Remove tim wire box fl'om tim end of the
blower condu it.
• Cut the leads al)proximately 3" fl'om the
plug.
• Cut a length of electrical cable to reach the
junction box. Use 14 gauge nan. electrical
cable (or conform to local codes).
• Attach the wire box and plug to one end of
the cable. Connect opposite end of cable to
blower leads in the junction box.
3-Pin Connector
Vent
r---i I ElectricalBox
I [_ I/(With vent)
PowerCable
III
(notincluded #4
IIIIII
with vent) Z
IIIIII
JunctionBox
IIIIII
(not inel e<J IIIIII
with vent) L_
!
To Slower
17