Installing A Media Card Reader - Dell Dimension 9150 Service Manual

Removing and Installing Parts: Dell Dimension 9150 Service Manual
8. Replace the computer

Installing a Media Card Reader

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body
before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface
on the computer chassis.
1. Follow the procedures in
2. Lay the computer on its side so that the system board is on the bottom of the inside of the computer.
3. Remove the computer
4. Remove the drive
5. Remove the Media Card Reader from its packaging and ensure that all four screws are included.
6. Gently slide the drive into place until you feel a click or feel the drive securely installed.
Ensure that the Media Card Reader is installed before the FlexBay cable is connected.
7. Connect the FlexBay USB cable to the back of the Media Card Reader and to the Media Card Reader connector on the
system board (see
file:///T|/htdocs/systems/dim9150/en/sm/parts.htm[10/31/2012 7:59:36 AM]
cover.
"Before You Begin."
cover.
panel.
"System Board Components").