Removing Lower Blower Assembly, Blower Seed Resistor, And Oven Thermal Cutoff - KitchenAid KEBS278SSS - 27" Double Wall Oven Technical Manual

REMOVING LOWER BLOWER ASSEMBLY, BLOWER
SPEED RESISTOR, AND OVEN THERMAL CUTOFF
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug oven or disconnect power.
WARNING
Excessive Weight Hazard
Use two or more people to move and
install oven.
Failure to do so can result in back or
other injury.
2. Remove the oven from its mounting location
(see "Installation Information" in Section 2)
and pull it forward so that you can access
the top cover.
3. Remove the six screws from the top cover
and remove the cover.
Screws (3 of 6)
Top Cover
4. Remove the twelve screws from the upper
rear cover of the oven and remove the
cover.
Upper Rear Cover
Blower Motor
5. To remove the blower assembly:
a) Disconnect the white and gray wires
from the blower motor terminals.
b) Remove the two screws from the blower
brackets.
c) Pull back on the blower assembly while
rotating it upwards and remove the as-
sembly.
Blower Motor Wires
Continued on the next page.
4-33
(12 Screws)
Blower
Oven Shutdown
TCO
Screws