Installation Procedures; Con Trol Unit; An Tenna; Wir Eloom - Avital AMX7 Installation Manual

Con trol Unit

1. Select a location under the dash that will allow you to use the tie wraps
to securely fasten the control unit.
2. Mount the control unit as high as possible to ensure maximum range.
3. Do not mount the control unit near moving parts.
4. Avoid areas that are in the direct path of air blowing from the vents.
5. Route wires from this point, leaving slack for ease of service.

An tenna

1. Do not shorten or lengthen the an tenna.
2. Route the antenna away from the control unit.
3. Keep the antenna as far away from metal and wire harnesses as possible
to optimize range.

Wir eloom

1. Plug the wireloom securely into the control unit.
2. Route wires from the control unit directly to each connection point.
3. Separate the RED, RED/WHITE, BLACK, VIOLET and TAN wires.
4. Sleeve the wires with vinyl tubing or electrical tape and route them
through an existing rubber grommet into the engine compartment.
5. If an existing grommet is not available, drill a hole and install a snap
grommet.

Im pact Sen sor

The sensor must be firmly mounted on a solid metal surface inside the
vehicle. We recommend tie wrapping the sensor to the steering column
housing or steering column support bracket. DO NOT mount the sensor near
moving parts or in the direct path of an air duct opening.
1. Plug the impact sensor BLUE 4 pin connector into the control unit
BLUE 4 pin connector.
2. Route the impact sensor to the chosen mounting location.
3. Using the long tie wraps supplied, securely fasten the impact sensor
allowing access to the adjustment screws.
Hurricane

Installation Procedures

6
2
/AMX78 (2) Installation Manual