Honda 2011 Odyssey Manual page 636

(Back-up light)
CONNECTOR
BASE GASKET
BULB
3. Remove the electrical connector
from the bulb by pushing on the
tab to unlock it, then slide the
connector off the bulb.
4. Remove the base gasket as shown,
then remove the socket by turning
it one-quarter turn
counterclockwise.
5. Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
6. Insert the socket back into the
light assembly. Turn it clockwise
to lock it in place.
TAB
7. Reinstall the base gasket.
8. Push the electrical connector back
onto the socket. Make sure it is on
SOCKET
all the way.
Turn on the lights to make sure
9.
the new bulb is working.
10. Reinstall the cover.
2011 Odyssey
(Taillight)
BULB
SOCKET
3. Remove the socket by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
4.
socket. Push the new bulb straight
into the socket until it bottoms.
Lights
633