Compass Zone Selection
In most areas, there is a variation
between magnetic north and true
north. Zone selection is required so
the compass can compensate for this
variation. To check and select the
zone, do this:
1.
Turn the ignition switch to the ON
(II) position.
2.
Press and hold the SETUP button
for about 5 seconds. The display
shows you the compass setting
menu items.
3.
Turn the selector knob to select
''ZONE'' or ''Zone Adjust.'' Press
the selector knob to enter your
selection. The display shows you
the currently selected zone
number.
U.S. EX models
EX-L and Canadian EX models
Find the zone for your area on the
4.
map (see page
). If the correct
478
zone is not shown, turn the
selector knob to cycle the zone
lists up or down.
If necessary, press the RETURN
button to return to the previous
display. Pressing the SETUP
button will cancel the compass
setting mode.
2011 Odyssey
U.S. EX models
EX-L and Canadian EX models
Once the correct zone is displayed,
5.
press the selector knob. The
display then returns to normal.
Compass
CONTINUED
477