Individual Settings For Scsi Drives - Acer M9N System User Manual

Table 5-2

Individual Settings for SCSI Drives

Item
Initiate Sync Negotiation
Maximum Sync Transfer Rate
Enable Disconnection
Send Start Unit SCSI Command 1
Initiate Wide Negotiation
When to Use the SCSISelect Utility
Use the SCSISelect utility if you need to do either one of the
following:
Change any of the default values listed in Table 5-1.
Check and/or change SCSI device settings that may conflict with
those of other devices
Perform low-level formatting on new SCSI disk devices
Running the SCSISelect Utility
A screen message giving the option to access the SCSISelect utility
appears after the BIOS and POST routine.
To start SCSISelect, press
appears during power on or system reset:
Press <Ctrl> <A> for SCSISelect
1
The settings are valid only if the host adapter BIOS is enabled.
System Utilities
Default
Yes
20 MB/sec.
Yes
No
Yes
+A when the following message
Utility!
5-5