Advanced Configuration Options - Acer M9N System User Manual

When set to Yes , the Start Unit Command is sent to the SCSI device
at system boot. When set to
normal procedure.
The Send Start Unit Command setting is
valid only if the host adapter BIOS is
enabled.
If this option is enabled for more than one SCSI device, the Start Unit
Command is sent first to the device with the lowest SCSI ID. When
this device responds to the SCSI controller, the Start Unit Command
is sent to the next highest SCSI ID with a setting of
continues until all supported devices respond to the SCSI controller.
If many drives are set to
time varies depending on how long it takes each drive to spin up.

ADVANCED CONFIGURATION OPTIONS

Selecting the Advanced Configuration Options displays a screen as in
Figure 3–8. Do not change the settings of the items under this
parameter unless it is absolutely necessary.
Figure 5-8 Advanced Configuration Options
System Utilities
, each SCSI device powers-up in the
No
Yes for Send Start Unit Command, the boot
Yes . The process
5-15