Fisher & Paykel AquaSmart WL26CW1 Installation Instructions & User Manual page 8

Illnstalllllati©n instlructions
Before you begin - read these instructions completely and carefully,
E_ectric Shock Hazard
Read and follow the SAFETY AND WARNINGS outlined in this User Guide
before operating this appliance, pages 3 - 5.
_mproper connection of an equipment-grounding conductor can result in a
risk of electric shock. Check with a qualified electrician or serviceman if you
are in doubt as to whether the appliance is proper_y grounded°
Do not modify the plug provided with the appliance - if it will not fit the
outlet, have a proper out_et installed by a qualified electrician°
Failure to do so can result in death, e_ectric shock, fire or injury to persons.
Observe all governing cedes and ordh_ances
InstaHatior_ Requirements
Location
Your washer must be installed on firm flooring to minimize vibration during spin cycles. Concrete
flooring is best, but wood base is sufficient providing the floor support meets FHA standards.
Your washer should not be installed on rugs or exposed to the weather.
Water Temperature
Your cold water should not exceed gS°F (35°C) or your hot water exceed 149°F (65°C).
Temperatures above this may damage your washer.
Shut Off Valves
Both hot and cold shut-off vabes (faucets) should be available n the laundry area.
Drain
Water may be drained into a standpipe or set tub/sink The standpipe must be 1 Y/' (38 ram)
minimum inter{or d{ameter and must be open to the atmosphere.
Electrical
This appliance must be supplied with 110V - 120V, 60Hz electrical supply and connected to an
individual, properly grounded branch circuit, protected by a 15 or 20 amp circuit breaker or time
delay fuse.