Fisher & Paykel AquaSmart WL26CW1 Installation Instructions & User Manual page 41

Befol°e you calllllfolr selrvice
The flow rate of the supply water may be too slow,
Check that the washer is not siphoning (refer to Installation instructions pages 6 -- 11).
Your washer has a suds buildup Too much detergent may have been used for the
amount of soil in the load
Ensure that you are using a HE Low Sudsing or Front Loader type detergent
Wait for suds to dissolve (about 20 minutes)
Rinse clothing using the RINSE and SPIN cycle, or run through another cycle.
Single
Check that the lid is closed.
Press START/PAUSE
if the symptom persists, call your Fisher and Paykel Dealer or Authorised Service
Center,
beep every second and °o°
3. Check your washer is level (refer to installation instructions pages 6 - 11).
4. Remove load and retry
5. Put through a RINSE and SPlN cycle (refer to pages 21 and27).
6. If the fault re-occurs repeat steps 1 and 2
If the washer still will not work, call your Fisher & Paykel Dealer or Authorised Service Agent to
arrange service (refer to page 45).