Fisher & Paykel AquaSmart WL26CW1 Installation Instructions & User Manual page 11

llr" starllllati©llL ilr stlructiolns
Drain hose
1 Carefully pull the drain hose out from the
back of the washer by pulling the exposed
part of the hose downwards and outwards.
2 To guide the drain hose over the set tub/sink
or standpipe the hose guide MUST be fitted
to the drain hose.
To prevent siphoning:
The: drain hose should not extend more than
¼"(20 ram) from the end of the guide.
The height of the standpipe or set tub/sink
should be between 33 V/'to 78"(850 - 1200 ram).
The drain hose can be trimmed to length.
Place the drain hose in the set tub!sink or
standpipe.
Pull hose
through guide
Flex hose
guide apart
fig.2 f itdr_g the drain hose guid_*
In multi-storey apartments or arty upper floor insta!ladon, the washer should be installed on a
drained floor_
Check that the tub or standpipe is free from lint or other obstructions before operating the washer.
In a basement in_taNadon do not exceed a stan@ipe height of gd" (2438 mm.L
Inlet hoses
1 Install hoses with the straight end (with filters) fitted to the faucets (refer to Fig.3).
2 Install elbow ends onto clothes washer (inlet valves are marked on the back of the washer
H=hot, C=cold) (refer to Fig.4).
_::7g.3 f :oucet end of hose _::7g.4 W osherer_dof hose