Making An Rci Expansion Setting; To Make An Rci Expansion Setting; To Confirm An Rci Expansion Setting - Fujitsu SPARC Enterprise M3000 Rci User's Manual

CHAPTER 2 Setup of the RCI for Operation
2.4.5

Making an RCI expansion setting

The added RCI host must be connected to the RCI network.
The RCI address of the added RCI host is synchronized with those of existing RCI
hosts so that the added cabinet can use RCI functions.
Make an RCI expansion setting on the added RCI host.
Note:
Note:

• To make an RCI expansion setting:

1
Execute the setrci (8) command, and make an RCI expansion setting.
XSCF> setrci -c addconfig
....................................................
The command completed successfully.

• To confirm an RCI expansion setting:

1
Execute the setrci (8) command to display the RCI status.
XSCF> setrci -c stat
HOST
address 000102ff
Active
LIST
address
000101ff OFF -
000102ff OFF -
003001ff OFF -
The command completed successfully.
Confirm that the displayed LIST contents include the added RCI host.
For details on LIST contents, see
2-8
Before beginning this RCI setup work, confirm that AC cables are connected
to all RCI units.
To make an RCI expansion setting for an RCI unit equipped with a main line
switch, set the main line switch to the ON position.
pwr alm I/F
ACT
ACT
ACT
sys-phase tgry dev-cls sub-cls tm-out
- host
- host
- disk
Chapter 3, "Command Reference."
0001 0b -
0001 0b -
0400 04 -
C120-E360-06EN