Fujitsu SPARC Enterprise M3000 Rci User's Manual page 46

CHAPTER 3 Command Reference
I/F
sys-phase
ctgry
dev-cls
sub-cls
tm-out
• "-c init" needs to be executed in the system power-off status.
• "When -c initconfig", "-c addconfig", or "-c replaceconfig" is being executed, or the
setrcic(8) command is being executed, do not execute the setrci(8) command on another
host.
• When the setrci(8) command is executed, set all RCI units that are connected to RCI into
the power-on state or standby state.
• Executing the setrci(8) command on a model that does not support the RCI function
causes an error to occur.
3-4
RCI unit interface status.
ACT Valid state.
INACT Invalid state.
Operating state of the host connected to RCI.
One of the following is displayed:
power-off Powered off.
panic In the panic state.
shdwn-start Shutdown in progress.
shdwn-cmplt Shutdown has completed.
dump-cmplt Dump has completed.
booting System being started.
running System in operation.
- Not support the status display.
Category of the RCI unit.
One of the following is displayed:
host Host unit.
disk File unit.
rcic External power control device.
linesw Line switch.
Other Other devices.
Device class of the RCI unit.
Subdevice class of the RCI unit.
Idle monitoring timeout period of RCI. Since it doesn't support the status
display, "-" is always displayed.
C120-E360-06EN