Sony HVR-1500A Operating Instructions Manual page 100

Alarm message on monitor
screen (Cause)
INPUT SIGNAL IS NOT A
DVCAM/DV SIGNAL.
CHANGE THE HD/SD SETTING.
CHANGE THE HDV/DV
SETTING.
THIS TAPE CANNOT BE
PLAYED BACK UNLESS THE
CURRENT SETTING OF
SYSTEM FREQUENCY IS
CHANGED.
INPUT SIGNAL IS A 625/50
SIGNAL.
INPUT SIGNAL IS A 525/60
SIGNAL.
THIS VIDEO SIGNAL CANNOT
BE INPUT UNLESS THE
CURRENT SETTING OF
SYSTEM FREQUENCY IS
CHANGED.
INPUT VIDEO SIGNAL IS NOT
SYNCHRONIZING WITH REF.
VIDEO SIGNAL.
COUNTER MODE IS SELECTED. SET COUNTER SELECT BUTTON TO
INPUT VIDEO CANNOT BE
DETECTED.
A NON-STANDARD INPUT
VIDEO SIGNAL IS BEING USED.
A NON-STANDARD REF VIDEO
SIGNAL IS BEING USED.
REMOTE CONTROL MODE IS
SELECTED.
INAPPROPRIATE SETTINGS
SELECTED IN SETUP MENU.
SET ITEMS IN THE SETUP
MENU TO THE APPROPRIATE
VALUES.
TC EXTERNAL IS SELECTED.
TCG REGEN MODE IS
SELECTED.
TCG RUN MODE IS SET TO REC
RUN.
BATTERY NEEDS TO BE
REPLACED WITH A NEW ONE.
FAN MOTOR DOES NOT
ROTATE.
100
Troubleshooting
Direction
–
TC OR UB.
CHECK THE VIDEO INPUT MODE
AND INPUT AN APPROPRIATE
VIDEO SIGNAL.
INPUT A STANDARD SIGNAL.
INPUT A STANDARD SIGNAL.
SET THE REMOTE CONTROL
SWITCH TO LOCAL.
CONTACT SERVICE PERSONNEL IF
THIS ALARM APPEARS AGAIN
AFTER TAKING ABOVE ACTION.
SET TC MODE (SETUP MENU) TO
INTERNAL.
SET TCG MODE TO PRESET.
SET TCG RUN MODE (SETUP MENU)
TO FREE RUN.
PLEASE CONTACT SERVICE
PERSONNEL.
POWER SUPPLY WILL BE SHUT
DOWN IN 1 MINUTE.
Alarm message in time counter display
Unknown sig
CHANGE SEL
50i Tape
60i Tape
625/50 sig!
525/60 sig!
50i INPUT!
60i INPUT!
ILL. REF!
CNT mode!
No INPUT!
VIN NON-STD
REF NON-STD
REMOTE!
ILL. SETUP!
TC EXT!
REGEN mode!
REC RUN!
Exchg batt!
FAN STOPPED