Setting The Ptz Control - Ptz Control Menu; Ptz Control Tab; Setting The Sensor Input/Camera Tampering; Detection/Motion Detection - Sony Ipela SNC-VB600 User Manual

Setting the PTZ control
— PTZ control Menu
When you click PTZ control
the PTZ control menu appears.

PTZ control Tab

Solid PTZ
Select On to enable the Solid PTZ function. You can set
Image 1, Image 2 and Image 3 separately.
Note
The Solid PTZ function is not available with Plug-in free
viewer.
OK/Cancel
See "Buttons common to every menu" on page 14.
26
Setting the PTZ control — PTZ control Menu / Setting the Sensor input/Camera tampering detection/Motion detection — Action input Menu
in the Administrator menu,
Setting the Sensor input/
Camera tampering
detection/Motion
detection

— Action input Menu

Action input
When you click
the Action input Menu appears. The Action input Menu
consists of the Event condition, Sensor input, Camera
tampering detection and Motion detection tabs.

Event condition Tab

Create event execute conditions for each action.
You can combine the following event execute conditions
together.
or: detect when either condition happens.
and: detect when both conditions happen within a
specified interval regardless of the sequence.
then: detect when each of the conditions happen within
a specified interval in sequence.
Interval
Specify the interval time used when condition is set to
and, then.
In the case the condition is set as 1 and 2, the system
sounds an alarm when either 1 or 2 happens, and the
other happens within the specified interval.
In the case the condition is set as 1 then 2, the system
sounds an alarm when 1 happens, and then 2 happens
within the specified interval.
If you select "or" condition, this setting will be ignored.
The maximum duration to be set is 7200 seconds.
You can select the alarm as follows:
Sensor input 1: The external sensor that is connected to
sensor input 1 of the camera I/O port.
Sensor input 2: The external sensor that is connected to
sensor input 2 of the camera I/O port.
Camera tampering detection: An alarm that is
triggered if the camera detects tampering, such as
direction shifting or spray.
VMF: The alarm detected by the VMF function.
Motion detection: The alarm detected by the motion
detection function.
Network disconnection: The alarm detected by
disconnection to a specific IP address.
in the Administrator menu,