Setting The Ptz Control - Ptz Control Menu; Ptz Control Tab; Serial Tab; Setting The Sensor Input/Camera Tampering - Sony SNC-VB635 User Manual

Setting the PTZ control
— PTZ control Menu
When you click PTZ control
the PTZ control menu appears.

PTZ control Tab

Solid PTZ
Select the checkbox to enable the Solid PTZ function.
You can set Image 1, Image 2 and Image 3 separately.
Note
The Solid PTZ function is not available with Plug-in free
viewer.
OK/Cancel
See "Buttons common to every menu" on page 18.

Serial Tab

Set this setting to control other devices connected via
RS-485 interface, in which a control signal (TCP/IP
packets) from the network is converted into an RS-485
signal. Recommended setting depends on the connected
device.
TCP port No.
Set the port number to any number in the range 1024 to
65535, except well-known port numbers.
Baud rate
Set the baud rate corresponding to the connected
devices. The available baud rates are as follows. 38400,
19200, 9600, 4800, 2400, 1200(bps)
Parity bit
Select the parity corresponding to the connected
devices, from [none], [odd], [even].
Character length
Select the character length corresponding to the
connected devices, from [8], [7] (bits).
Stop bits
Select the stop bits corresponding to the connected
devices, from [2], [1] (bits).
OK/Cancel
See "Buttons common to every menu" on page 18.
Setting the PTZ control — PTZ control Menu / Setting the Sensor input/Camera tampering detection/Motion detection — Action input Menu
in the Administrator menu,
Setting the Sensor input/
Camera tampering
detection/Motion
detection

— Action input Menu

Action input
When you click
the Action input Menu appears.
The Action input Menu consists of the following tabs:
Event condition, Sensor input, Camera tampering
detection, Motion detection, Face detection and
Network disconnection.
When the Motion detection or Face
detection tab is displayed for the first
time
When you click Motion detection or Face detection,
"Security Warning" is displayed. When you click Yes,
ActiveX control is installed and the Motion detection or
Face detection tab is displayed.
Notes
• If Automatic configuration is enabled in the Local
Area Network (LAN) settings of Internet Explorer, the
image may not be displayed. In that case, disable
Automatic configuration and set the proxy server
manually. For the setting of the proxy server, consult
your network administrator.
• When you install ActiveX control, you should be
logged in to the computer as Administrator.

Event condition Tab

Create event execute conditions for each action.
Event condition 1, 2, 3, 4, 5
Select the event condition.
You can combine the alarm using the following event
execute conditions.
and: detect when both conditions happen within a
specified interval regardless of the sequence.
or: detect when either condition happens.
then: detect when each of the conditions happen within
a specified interval in sequence.
If you set the event condition to None, the following
alarm 1, 2, 3 menus appear.
1, 2, 3
Select the alarm.
Selectable alarms are as follows;
in the Administrator menu,
39