Final Installation; Door Replacement And Adjustment - Viking RVER330 Installation Manual

Floor Mount Anti-tip Installation
3
x2
Remove two screws from back of range.

Final Installation

5
Slide range into place and check that hook and bracket
are engaged.
1
Connect electrical in shaded area. See the "Electrical
Requirements" section for more information.
22
(cont.)
4
Attach bracket to back of range using two screws.
Note: Refer to range electrical
requirements section for proper
installation information.
2
Slide range into place. Be sure anti-tip
bracket slides into the anit-tip opening.
Door Replacement and
Adjustment
3
" " "
3 / 8 3 / 8 3 / 8
) ) )
c m c m c m
9 5 9 5 9 5
( 0 . ( 0 . ( 0 .
Check that unit is level side to side
and front to back. The side trim must be 3/8" (0.95 cm)
above countertop. If unit is not level repeat Steps 5-7
of "Leveling/Adjustments/Alignment" section.
2
1
Open door completely. Reattach hinge trim.
4
Close door. If the door needs to be adjusted, loosen hinge trim screws (see Step 2).
Adjust the screws located between the door and kickplate using a 5/32"
hex head allen wrench. After adjustment, tighten hinge trim screws.
23
1
Reattach door to range.
3
Remove pins from hole in hinges.
5