Table of Contents
Advertisement
(2)
Select
Vertical
The Select Vertical Pitch command specifies the printer line feed pitch (6
or 8 lpi).
When 6 lpi is specified, the parameter is 31 32 30, as follows:
or i
3 1 3 2 ab 2 0 4 7
9 B
When 8 lpi is specified, the parameter is 39 30, as follows:
or
39 30 20 47
9 B 17
If the parameter has a value other than the value abcve, it is regarded as
an invalid control sequence and the specified operati,on is not performed.
(3) Set to Initial State command
The Set to Initial State command returns the FCB (EVFU) contents to the
set value, clears the horizontal control buffer (HCB) in which the
horizontal tab stop data is loaded, returns the printer line feed pitch to
that specified by the setting, and inhibits the printer from translating
data codes when the printer receives the SO code.
However, an error caused by the printer, for example, hammer check or band
speed
check, is not cleared.
(4) Skip to Channel-n command
The skip to Channel-n command directs the printer to feed forms up to the
line corresponding to the channel specified in the FC:B
received before this command is printed.
by the parameter as follows:
This control sequence is regarded as invalid under thse
conditions:
. The .channel specified in this connnand
even though the FCB (EVFU) is loaded.
. This command is specified even though the FCB is not loaded.
forms up to the TOF line.
Pitch
command
Parameter
2
3
4
5
6
data after data
The channel number is specified
7
Channel 8
Channel 9
following
is not present in the FCB (EVFU)
If
channel
6 - 23
Advertisement
Table of Contents
