Table of Contents
Advertisement
5.4.2 Loading from an FCT to the FCB
The FCT is a looped paper tape with punched holes and sprocket holes for
There are 2
feeding.
data is read by the FCT unit and loaded in the FCB.
The FCT is read automatically when the printer is turned on or when the RUN
switch on the FCT unit is pressed in offline mode.
new FCT to be read.
is the start position, the FCT unit reads punched hole data
channel 1 to the next channel 1 detected and sends the read data as a forms
feed format.
See Section 4.4.2 for the method for making an FCT.
5.4.3
Format
specification
The number of lines per page is used to specify the page len:gth
operator
panel.
specified with 8 LPI, even if the form is the same length.
The number of
lines skipped to avoid printing on or too near a perforation can
be specified from the operator panel.
setting
method, refer to
5 - 16
types of FCT; &channel and 12-channel.
Because the FCT unit determines that channel 1 of the FCT
from
the
Thus, a page length specified with 6 LPI differs from that
Operator's
operator
panel
(Skip-over
perforation
Guide.
The punched hole
The RZN :switch
enables a
starting from
from the
feature)
For
the
Advertisement
Table of Contents
