(2)
Forms
container
If the forms catch on container lids when being fed, feed errors may
occur.
Therefore arrange the lids as shown in Figure 2.9.
Inside space between the forms and container should be 4 to 7 mm (0.16" to
0.28").
The bottom of the box must be flat.
The forms container height must be 330.2 rmn (13") or less to be installed
in the forms hopper.
If the form length or folding dimension is more than IS":,
rear doors must be open during operation.
2.5.2
Dimensions
This section describes dimensions of the forms, printing area, pin feed holes.
and
perforations.
(1)
Forms
dimensions
Forms
width:
Forms
length:
2 - 12
Allowable
Figure
2.9
(Top
view)
Figure 2.10 Shape of the forms container
76.2 to 431.8 mm (3" to 17")
76.2 to 381 m (3" to 15")
Unallowable
Forms
container
(Side
view)
lids
See Figure 2.10.
the front and