Table of Contents
Advertisement
(6) FF (X'OC') code
The FF code directs the printer to feed fo~rms
on the next page.
If forms
is loaded, the line on which channel 1 is specified is Ithe line at the
TOF.
If the printer receives print data before receiving.this
the data, then feeds forms.
column 1.
(7) CR (X'OD') code
The CR code sets the horizontal print position in column
printer receives print data before receiving this code, it prints the
data, then sets the horizontal print position to column 1.
If the Automatic New Line on CR Code function is set from the operator
panel, the printer feeds one line in addition to performing the operation,
above.
(8) SO (X'OE') code
The SO code translates character codes X'Z.1'
The SO code is valid if 7SI/SO
operator
regard it as an invalid code.
stops
data
When receiving an 91 code after an SI code or when receiving an SO code
after an SO code, the printer ignores the second SI or SO code and the
printer state does not change whether data codes are to be translated or
not.
(9) ESC (X'IB') code
The ESC code indicates that the data following it is ccsntrol
in 7-bit mode.
For the control sequence, see Section 6.5.
6 - 18
control buffer (FCB; in this manual,
If nclt,
panel.
code
translation.
Then, the horizontal print position is set to
mode is selected in setup DT BIT from the
the printer ignores this code, but does not
When receiving the SI code, the printer
up to the line at the top of
it is also called EVFU) data
code, it prints
1.
If the
sequence dat-
Advertisement
Table of Contents
