Messages Displayed On The Client Computer - Ricoh MP C4503 Series User Manual

Message
"Memory is full. Press [Write]
to write the current scanned
data to the memory storage
device, or press [Cancel] to
delete."

Messages Displayed on the Client Computer

This section describes likely causes of and possible solutions for the main error messages displayed on
the client computer when using the TWAIN driver. If a message not described here appears, act
according to the message.
Message
"Any of Login User Name,
Login Password or Driver
Encryption Key is incorrect."
"Authentication succeeded.
However, the access
privileges for scanner
function has been denied."
"Cannot add any more
scanning mode."
"Cannot detect the paper
size of the original. Specify
the scanning size."
Causes
The scan could not be
completed because there
was insufficient hard disk
memory at the time of saving
to the memory storage
device.
Causes
The entered login user
name, password, or driver
encryption key was invalid.
The logged in user name
does not have permission for
scanner function.
The maximum number of
registerable scan modes has
been exceeded.
The set original was
misaligned.
Messages Displayed When Using the Scanner Function
Solutions
Select whether or not to save the
scanned document to the memory
storage device.
Solutions
Check your login user name, login
password, or driver encryption key,
and then enter them correctly. For
details about login user name, login
password, and driver encryption key,
see Security Guide
For details about how to set
permissions, see Security Guide
The maximum number of modes that
can be stored is 100. Delete unneeded
modes.
• Place the original correctly.
• Specify the scan size.
• When placing an original directly
on the exposure glass, the lifting/
lowering action of the ADF
triggers the automatic original
size detection process. Lift the
ADF by 30 degrees or more.
.
.
211