Table of Contents
Advertisement
Back to Contents Page
Module Cover
Dell™ Inspiron™ 1546 Service Manual
Removing the Module Cover
Replacing the Module Cover
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
Removing the Module Cover
1. Follow the procedures in
Before You
2. Remove the battery (see
Removing the
3. Loosen the four captive screws that secure the module cover to the computer base.
4. Lift the module cover off the computer at an angle as shown in the figure.
1
module cover tabs (4)
3
captive screws (4)
Replacing the Module Cover
1. Follow the procedures in
Before You
2. Align the tabs on the module cover with the slots on the computer base and gently place it in position.
3. Tighten the four captive screws that secure the module cover to the computer base.
4. Replace the battery (see
Replacing the
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Back to Contents Page
Begin.
Battery).
2
module cover
Begin.
Battery).
Removing the
Battery) before working inside the
Advertisement
Table of Contents
